Ultrasonic vibrating screen introduces a low amplitude and high frequency ultrasonic vibration wave (mechanical wave) on the screen mesh based on the traditional vibrating screen to improve the screening performance of ultra-fine powder. It is especially suitable for users of fine powder with high added value.
1.Ignition of transducer vibrator: ceramic materials are broken, which can be checked with naked eyes and megger. Generally, as an emergency treatment measure, individual damaged vibrators can be disconnected without affecting the normal use of other vibrators.
2. Ultrasonic vibrator is affected with damp: the plug connected to the transducer can be checked with a megger, and the basic situation can be determined by checking the insulation resistance value. Generally, the insulation resistance is required to be greater than 5 megohms. If the insulation resistance value cannot be reached, the transducer is generally affected with moisture. You can put the transducer into the oven and set it at about 100 ℃ for drying for 3 hours or use a hair dryer to remove moisture until the resistance value is normal.
3. Degumming of the transducer: the transducer adopts the double assurance process of cementation and screw fastening, which generally occurs; Generally, if the transducer is used at full load for 10 years, there may be abnormal noise in the use and daily maintenance of the vibrating dewatering screen;
4. After use: Clean up after each use
